1. Home
  2. Customer Service
  3. Standard Tolerances

Standard Tolerances

• Hole Sizes:
• .015″ to .025″ over the listed dimensions unless specifically mentioned.
• Product inside diameter (ID) and outside diameter (OD):
• Produced within commercial, dimensional tolerances.
• Bend Tolerances and Angle of Bend:
• +/- 2°.
• Cutting Tolerances on Pipe and Tube:
• +/- 1/16″.
• Multiple Bend Tolerances:
• +/- 2° and +/- 1/8″ center-to-center through 2.50″ OD.
• +/- 1/4″ center-to-center above 2.50″ OD.

Updated on June 12, 2018

Was this article helpful?

Related Articles

Leave a Comment